Keyboard, Mouse and other input devices cables and adapters scheme  > Belkin pinouts
Belkin DB9-to-RJ11 Serial Flash Cable schematic

This is a cable pinout for Belkin KVMs with RJ11 for Flashing ( OmniView Pro3: F1DA104Z, F1DA108Z or F1DA116Z - maybe others but this have to be verified).

 

DB-9
Pin Number
DB-9
Pin Name
Direction KVM RJ11
Pin Number
KVM RJ11
Pin Name
Description
2   RXD <-- 1 Tx Receiver 
3   TXD --> 2 Rx Transmitter 
5 GND  --- 4 GND Ground 
All other pins have to be left unconnected.

Tested with Belkin OmniView Pro3 8-port KVM ( F1DA108Z ) .

For firmware update instruction (for OmniView Pro3) look for document "Firmware Upgrade Instructions for Pro3 KVM Switches", to update, use dedicated application "Upgrade Utility 1.2" (or newer - should be available with the firmware for your OmniView).

9 pin D-SUB female connector layout
9 pin D-SUB female connector
at the PC
4 pin RJ11 male connector layout
4 pin RJ11 male connector
at the KVM
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
This page contain parts under Copyright © 2000-2018 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinoutguide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.