RS-232 and other serial ports and interfaces  > HP pinouts

Printer Side ("Next device connector", single dot port, output port):

Pin
Number
Pin
Name
Description
1   /TX (Data Out)   
2   GND   
3   /RX (Data In)   
4   TERMINATE IN   
5   +24V   
6   /CLOCK   
7   GND   
8   GND   
9   GND   
10   +24V   
11   GND   
12   /STROBE   
13   POWER ON OUT   
14   GND   
15   +24V   

 

Accessory Side ("Previous device connector", double dot port, input port):

Pin
Number
Pin
Name
Description
1   /TX (Data In)   
2   GND   
3   /RX (Data Out)   
4   TERMINATE OUT   
5   +24V   
6   /CLOCK   
7   GND   
8   GND   
9   GND   
10   +24V   
11   GND   
12   /STROBE   
13   POWER ON IN   
14   GND   
15   +24V   

 

Note: Daisy chain connections are from single dot ports ("Next device connector") to double dot ports ("Previous device connector").

Example LaserJet 8100 supported chain: Formatter Single Dot -> 2000-sheet or 2x500-sheet Input Tray Double Dot -> 2000-sheet or 2x500-sheet Input Tray Single Dot -> 8-bin Mailbox or 7-bin Mailbox (no Stapler) Double Dot ->  8-bin Mailbox or 7-bin Mailbox (no Stapler) Single Dot -> Stapler Double Dot -> Stapler Single Dot -> End of chain

To make a connecting cable join all pins in a straight through configuration. 

 

 

15 pin highdensity D-SUB female connector layout
15 pin highdensity D-SUB female connector
at the Next device connector (Single Dot)
15 pin highdensity D-SUB female connector layout
15 pin highdensity D-SUB female connector
at the Previous device connector (Double Dot)
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinoutguide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.