Hardware pinouts information and cables schemes

Ford OBD-II diagnostic interface specification users reports and reviews

[Discuss at the forum] [SUBMIT new pinout]

There are 12 approved reports in our database

Date Content
Revision
User opinion Comment Approved by moderator?
2010-11-27 05:12:42rev. 3ERROR FIXEDpins: 3, 11 used for low speed (125kb) CAN bus. This bus used for same IC, RFA and other units. pin3 - hi pin11 - loAPPROVED
2014-12-10 00:07:07rev. 5INCORRECTOn a 2000 expedition the CAN + is pin 10 and it doesn't pinpoint what Pin 13 is.APPROVED
2016-03-23 00:38:50rev. 5ERROR FIXEDI need the square obd or can connector for the 1996 Ford falcon Futura with actve Torque controlAPPROVED
2016-05-16 23:19:31rev. 6CORRECTAPPROVED
2016-09-21 22:14:25rev. 6INCORRECTpin 14 should be can highAPPROVED
2017-06-23 12:56:37rev. 7CORRECTat ford new models have MS-CANAPPROVED
2017-09-29 02:34:44rev. 7CORRECTlooks to be what is in my Ford Ranger wiring diagramsAPPROVED
2018-01-29 04:39:06rev. 7ERROR FIXEDmy pin layout being used is 2,4,5,7,10,13,16. Vehicle is 1999 Ford Explorer Can not find info for pin 13. Thanks for the help.APPROVED
2018-06-13 23:34:51rev. 8CORRECTAPPROVED
2019-07-02 15:34:18rev. 8CORRECTIt would help to know the volt range required at each pin locationAPPROVED
2020-11-30 00:55:37rev. 8CORRECTAPPROVED
2021-04-20 17:13:34rev. 8CORRECTThe obd2 shuts down the gps unit when it reads the vin. is this a function of shuting down the engine?APPROVED


History of users contributions

Date Content
Revision
Author Comment

Back to Ford OBD-II diagnostic interface pinout


Pinouts.ru > Pinout of Ford OBD-II diagnostic interface
should be correct