Pinouts >  Диагностические интерфейсы легковых автомобилей, мотоциклов и грузовиков
9 pin D-SUB female connector layout
9 pin D-SUB female connector

ISO 9141-2. This protocol has an asynchronous serial data rate of 10.4 kbit/s. It is somewhat similar to RS-232; however, the signal levels are different, and communications happens on a single, bidirectional line without additional handshake signals. ISO 9141-2 is primarily used in Chrysler, European, and Asian vehicles.

  • pin 7: K-line
  • pin 15: L-line (optional)
  • UART signaling
  • K-line idles high, with a 510 ohm resistor to Vbatt
  • The active/dominant state is driven low with an open-collector driver.
  • Message length is Max 260Bytes. Data field MAX 255.

Simple OBD-2 iso9141-2 RS-232 cable schema

Components:
 

R1,2,6,7,9,10 - 560 ohm, 0.25W
R3,4,5,8 - 4K7 OHM, 0.125w
T1     - BC556 or 2N3906
T2,T3  - BC546 or 2N3904

One of our users reports that from collector of t1, r4 has to go to GND.

 

See also PC RS232 interface details.

Tx is -12V when inactive. therefore the diagram correctly shows that r4 goes to tx because it uses the -12V to pull down Rx when RS232 is in Rx mode.

16 pin J1962 OBD-2 car diagnostic connector layout
16 pin J1962 OBD-2 car diagnostic connector
На распиновку OBD-2 ISO 9141-2 (14230-4, KWP2000) simple RS-232 cable schematic есть 11 отзыв(а): 9 положительных и 2 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: hem.passagen.se/tomasf/obd2/
Copyright © 2000-2021 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinoutguide.com .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.