Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector pinout and wiring @ old.pinouts.ru

The Palm Serial Connector used before 2000/2001.

Pin	Signal	Description
1	DTR	non-standart implementation of DTR. As long as the transceiver is enabled this pin outputs an asserted signal. 3.0 volts when transceiver shutdown (normal mode), 6.0 volts when transceiver enabled (Hotsync)
2	Vbat, +3.3v	normally connected to HotSync (pin 7) with button
3	RxD	GPS T
4	RTS
5	TxD	GPS R
6	CTS
7	HotSync IRQ	link to 3.3v (pin 2) for HotSync. Interrupt line for waking up device (initiate HotSync process in PalmOS).
8	ID	Palm modem connect this pin to 3.3v (pin 2) by 20Kohm link
9	N/C*	DC In in Palm III (+5VDC)
10	GND	GPS -

*Palm V does not contain an internal charging circuit.

Maximum transmission rate is 115200 bps (57600 bps for modem).

Here is Palm Serial cable scheme

According to 7 reports in our database (5 positive and 1 negative) the Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector pinout should be correct.

Is this pinout

correct

incorrect

If you did publish instruction for Do-It-Yourself device with this pinout, share the link with us.

Source(s) of this and additional information: kolumbus.fi

Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.

connector or cable wiring scheme

Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector pinout