|
VGA (VESA DDC) specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| INCORRECT | APPROVED | |||
| CORRECT | APPROVED | |||
| CORRECT | Same pinout as my monitor. | APPROVED | ||
| CORRECT | Good design! | APPROVED | ||
| CORRECT | Note that pin 9 is generaly the key, so the pin is missing on the male connector (monitor cable) | APPROVED | ||
| CORRECT | APPROVED | |||
| 2008-09-09 07:18:34 | rev. 2 | INCORRECT | The digram does not show the case to case connection which is normally connected via the screen at both ends. But I have seen an barticle advocating a screen connection only at one end. But I think screen connection at both ends is needed to maintain full RFI and EMI protection | APPROVED |
| 2010-01-12 17:05:39 | rev. 2 | CORRECT | APPROVED | |
| 2010-06-03 21:08:12 | rev. 2 | CORRECT | APPROVED | |
| 2010-07-25 18:12:03 | rev. 2 | CORRECT | works for my home-made kvm | APPROVED |
| 2012-08-10 23:44:29 | rev. 2 | CORRECT | correct :) | APPROVED |
| 2012-11-10 21:34:03 | rev. 2 | CORRECT | APPROVED | |
| 2016-10-18 22:25:55 | rev. 2 | CORRECT | APPROVED | |
| 2017-11-10 00:11:52 | rev. 2 | CORRECT | APPROVED | |
| 2017-11-10 00:12:11 | rev. 2 | CORRECT | APPROVED | |
| 2019-11-24 18:13:57 | rev. 2 | CORRECT | APPROVED | |
| 2019-11-24 18:14:12 | rev. 2 | CORRECT | APPROVED | |
| 2020-07-27 13:47:38 | rev. 2 | CORRECT | APPROVED | |
| 2021-01-31 04:36:16 | rev. 2 | CORRECT | APPROVED | |
| 2022-06-05 21:43:25 | rev. 2 | CORRECT | nope | APPROVED |
| 2024-10-25 12:34:42 | rev. 2 | CORRECT | What pins are required to keep the back light on, without a monitor cable plugged in? | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|
Pinouts.ru > Pinout of VGA (VESA DDC) and layout of 15 pin highdensity D-SUB female connector and 15 pin highdensity D-SUB male connector |
should be correct |