|
RS-422 (9 pin) specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| INCORRECT | This says 9 pin and only shows 4. | APPROVED | ||
| INCORRECT | Not all pins are accounted for | APPROVED | ||
| 2009-02-02 06:23:39 | rev. 2 | CORRECT | This pinout scheme is correct. RS422 is only 4 wires, the rest are NC | APPROVED |
| 2009-02-03 11:54:11 | rev. 2 | CORRECT | I have aja kona Lhe card with breakout cable with remote RS422 connector macos and fcp editing software i have panasonic AJD-450,455 recoders but remote controller for editing point of u capture tool is hung for remote throug and with out remote working fine .pls give me a solution for me. | APPROVED |
| 2009-02-20 10:03:11 | rev. 2 | INCORRECT | RS422, D9 should be pin3 = TX-; pin2 = RX+; pin7 = RX-; pin8 = TX+. | APPROVED |
| 2009-11-11 23:29:11 | rev. 2 | INCORRECT | typically pins used are 2, 3, 7, 8. COM typically on 4 or 5 - usually depends on the equipment where to pin COM. | APPROVED |
| 2011-11-22 12:19:15 | rev. 2 | INCORRECT | APPROVED | |
| 2016-03-03 16:17:20 | rev. 2 | INCORRECT | APPROVED | |
| 2016-10-10 19:24:24 | rev. 2 | INCORRECT | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2010-02-27 22:09:21 | rev. 2 | ||
| 2010-04-27 21:35:25 | rev. 2 | Oleg Sazonov | |
| 2010-10-28 21:18:14 | rev. 2 | Sebastian Mueller | Thank you |
| 2011-11-24 21:14:54 | rev. 2 |
Pinouts.ru > Pinout of RS-422 (9 pin) and layout of 9 pin D-SUB female connector |
may be incorrect |