|
USB header internal connector specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| CORRECT | APPROVED | |||
| CORRECT | works | APPROVED | ||
| CORRECT | APPROVED | |||
| CORRECT | APPROVED | |||
| CORRECT | Its correctly! | APPROVED | ||
| CORRECT | This is what is known, I believe, as the Intel standard. There is another standard used on many motherboards, such as PCChips M755: as follows (using YOUR pin numbering scheme of 1 to 10) 1-Vcc; 3-NC;5-D1-;7-D1+;9=GND 2-GND;4-D2+;6-D2-;8-NC;10-Vcc normally implemented as TWO 5-pin connectors | APPROVED | ||
| CORRECT | Oh, its right, I think. On all internal cardreaders I have seen this pinout is right. | APPROVED | ||
| 2009-11-22 17:32:18 | rev. 6 | CORRECT | APPROVED | |
| 2009-11-26 16:22:46 | rev. 6 | CORRECT | APPROVED | |
| 2010-02-28 00:14:49 | rev. 6 | CORRECT | APPROVED | |
| 2011-11-29 19:12:36 | rev. 6 | CORRECT | APPROVED | |
| 2012-02-18 22:26:38 | rev. 6 | CORRECT | APPROVED | |
| 2012-04-09 13:48:39 | rev. 6 | CORRECT | On cables there are often five wires, I guess the last one is used for shielding, maybe on motherboards, pin 9 and 10 provide shield grounding? | APPROVED |
| 2012-04-21 18:47:38 | rev. 6 | CORRECT | APPROVED | |
| 2018-04-16 12:38:18 | rev. 9 | CORRECT | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2008-07-27 19:38:23 | rev. 2 | Dr.Edelon | My self exp. In most MB USB pin for 2nd port is reversed. V+ swap with GRND and D- wint D+ ! Detect direction by power pins befor connect. |
| 2009-02-21 22:24:37 | rev. 4 | Leon Loopik | N/C is not connected to USB port 2 ;-) |
| 2009-07-07 21:34:22 | rev. 4 | out dated. | |
| 2009-08-07 17:42:01 | rev. 6 | Petrovi4 | amendment to article |
| 2009-08-15 11:59:01 | rev. 6 | ||
| 2018-05-03 19:44:07 | rev. 9 | Sopor | fixed a few typos |
Pinouts.ru > Pinout of USB motherboard internal connector and layout of 10 pin IDC male connector |
should be correct |