Pinouts >  MP3 плееры и гаджеты  >  Uniden pinouts
6 pin RJ12 (6P6C) male connector layout
Разъем 6 pin RJ12 (6P6C) male

The 2 center pins (3&4 on RJ12, 2&3 on RJ11) are the primary pair (long runs are normally twisted). The 2nd pair straddles the first at 2&5 on RJ12, 1&4 on RJ11.  The 3rd pair straddles the 2nd at 1&6 on RJ12, not exist on RJ11 because only has 4 pins. If the (android/iOS) serial data link isn't needed (or not exist on some models), then RJ11 (no 3rd pair) works fine. If remote Mute & Alert aren't needed, only the center [primary] pair are used. 

Remember that if viewing the plug (male) end with PINS FACING UP, the numbers go from RIGHT-2-LEFT.

** The Alert output signal may require a driver transistor to light an LED.
 

Pin
Number
Pin
Name
Description
1   D0   - data
2   Mute   button (in)
3   GND   - power
4   +12V   + power
5   Alert   LED (out)
6   D1   + data

On the Escort 4 pin RJ11 connector, Black Ground (GND) is Pin 2 and Red +12v is Pin3.

On Uniden R4 positive and negative are reverse too.

4 pin RJ11 male connector layout
Разъем 4 pin RJ11 male
На распиновку Escort/Bel/Uniden/V1 radar detector RJ11/RJ12 power cord есть 6 отзыв(а): 5 положительных и 0 отрицательных.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings