Pinouts >  MP3 плееры и гаджеты
5 pin Micro USB A, Micro USB B plug connector layout
Разъем 5 pin Micro USB A, Micro USB B plug
Allows portable devices (such as cell phones which support OTG) to connect directly to other devices such as USB keyboards, mice and mass-storage devices.
Micro Pin # Pin
Name
Description Standard Receptacle Pin #
1 VCC +5V Power supply, COLOR : RED 1
2 D- Data- Signal line, COLOR : WHITE 2
3 D+ Data+ Signal line, COLOR : GREEN 3
4 ID Tells the OTG device to act as host and if it is allowed to charge (See note below) NC
5 GND Ground COLOR : BLACK 4

Note-The ID pin can be directly connected to ground. This will tell the OTG device that it can not charge (and hence must supply current to VCC) but should act as a USB host. The ID pin can also have a 124 kΩ impedence to ground (see below). This will tell the OTG device that it is allowed to draw current off VCC (e.g. charge its battery) as well as act as a USB host.

The 124  kΩ mode is slightly more complicated to wire: place a 124 kΩ resistor between ID and GND. Attach proper ends of a regulated 5 V charger to VCC and GND. Attach a 10-100 nF capacitor between VCC and GND. Be sure that the charger is connected, otherwise both the OTG device and slave device will try and draw current from VCC without a source. The infomation in this paragraph was inferred as the simplest way to construct an accessory charger adapter as specified in the Battery Charging Specification, Revision 1.2 from www.usb.org website. It has not been tested.

Also note that on the slave side, it is not standard to have a USB B standard recepticle. Only USB A standard recepticle should be used.

4 pin USB A receptacle connector layout
Разъем 4 pin USB A receptacle
На распиновку USB Micro Plug to USB Standard receptacle for use with USB OTG (On-The-Go) есть 2 отзыв(а): 2 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: https://web.archive.org/web/20131030042545/http://www.usb.org/developers/devclass_docs/batt_charging_1_1.zip http://forum.xda-developers.com/showthread.php?t=1828032
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings