UPS devices  > APC pinouts
Should work with APC UPSs that use the following cables: APC Part# 940-0024C, # 940-0024D or 940-1524(black cable) This is to plug a Cisco console (rollover) cable into.

 

UPS
Signal Name
DB-9 Male
(UPS end)
RJ45 Female
(Adapter end)
Adapter
Signal Name
TX 2 3 Rx, Received Data
RX 1 6 Tx, Transmitted Data
Common 9 4 GND

Might be needed in some cases: pins 8,1 (RTS, CTS) shorted.

 

Terminal Set Up:

2400 baud

8 bit no parity

1 stop

no handshake

9 pin D-SUB male connector layout
9 pin D-SUB male connector
at the UPS
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinoutguide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.