S-Video, SCART and other video/audio cables scheme  > CheckPoint pinouts
The CheckPoint UTM-1 Has a standard vga output (it is a pc with big ass network interfaces :)) Video signal was easy, measured 75ohms to ground with the multimeter and V H sync signals figured it out with the oscilloscope 31Khz and 60Hz, the only difficult was SDA and SCL signals, since i have to no way to know it at the motherboard side, i take a gamble and connected it trough a 330ohms resistor to the vga 15 pin connector (in case i got it wrong), here it is. it is easy to see if SDA/SCL is reversed because monitor will not be identified by the video card, if that happens, reverse it and that's it, remember to use 330ohms in series between the IDC connector output and the vga, in both lines, it is not really necessary but a good measure to protect the monitor.

 

Pin
Number
Pin
Name
Description
1 R Red Video
2 SDA SDA (though 330ohms  just in case)
3 G Green Video
4 GND GND
5 B Blue Video
6 SCL SCL (through 330ohms just in case)
7 VSYNC Vertical Sync
8 GND GND
9 HSYNC Horizontal Sync
10 GND GND

 

10 pin IDC keyed male connector layout
10 pin IDC keyed male connector
at the Left side (near the power supply)
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
CheckPoint Firewall UTM-1 570 (U-20) internal VGA connector visual pinout:
CheckPoint Firewall UTM-1 570 (U-20) internal VGA connector diagram
click to enlarge
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinoutguide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.