Pinouts >  Распиновки разъемов аудио/видео техники  >  Shure pinouts
TA4 TA4F TA4M for Shure Beltpacks
Pin
Number
Pin
Name
Description (may be empty)
Pin 1 Shield (ground)  Says by itself...
Pin 2 Bias (+5Vdc)  
Pin 3 Audio +  
Pin 4 20 k Ohm resistor to ground  (Link to pin 3 when connecting to condenser microphones. Instrument input - leave unconnected)

These are for Shure beltpacks only as each manufacturer has it's own pinout standards for ta4 connectors. JTS, Carvin Wireless and AMX beltpacks also have the same pinout.

Pin 2 needs to be linked to pin 3 via a 2k2 resistor for Da-Cappo Condenser microphone.

Pin 2 needs to be linked to pin 3 via a 8.2k resistor for Sennheiser HSP 4.

NB: Non-condenser microphones (That does not require Phantom Power) are to be considered as Instruments and -must- be linked -Only- to pin 1 (Ground) and 3 (Audio +); even if some of these non condenser microphones may have 3 wires to connect.

На распиновку TA4 TA4F TA4M for Shure Beltpacks есть 7 отзыв(а): 7 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: http://www.blue-room.org.uk/lofiversion/index.php/t26213.html, Shure WH-20 User manual
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings