Pinouts >  Chrysler, Fiat, Dodge, Jeep Car audio harness  >  Fiat pinouts
Grundig AD182H and AD185H (x)
A: Power B: Speakers C: Changer / special
1. weight (x) 1. RR 1. -
2. tel mute (x) 2. RR - 2. -
3. ant control (x) 3. RF 3. -
4. +12 V ACC 4. RF - 4. -
5. - 5. LF 5. -
6. Illumination 6. LF - 6. -
7. +12 V BATT 7. LR 7. -
8. Ground (-) 8. LR - 8. pilot - mass
Radio has a logic of ignition, so the pros are swapped places.  
  • R - right (right)
  • L - Left (left), second letter indicates the location of
     
  • R - Rear (rear)
  • F - Front (front) 
    - means the negative speaker terminal 
    Note: Do not connect (-) with the mass of the vehicle and may damage the amplifier.
9. pilot - in
10. -
11. -
12 -
13. CD-Bus
14. -
15. CD-Bus GND
16. 12 V constant
17. +12 V from the radio-controlled
18. CD-NF GND
19. NF CD-Left
20. Right-NF CD
CD Changer Interface 13-20

This is a standard Grundig MCD36/40. Some versions have a car with the steering wheel radio controls, and if it is connected to the remote connector (not always on the radio is a connector). This is a typical resistor ladder. The contacts marked (x) occur only in the model AD185H. 

36 (20+8+8) pin Head Unit / Car Stereo ISO connector layout
36 (20+8+8) pin Head Unit / Car Stereo ISO connector
at the head unit
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
This page contain parts under Copyright © 2000-2019 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinoutguide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.