Pinouts >  Разъемы сотовых телефонов и смартфонов  >  Apple pinouts
30 pin Apple iPod proprietary dock connector layout
Разъем 30 pin Apple iPod proprietary dock
Used in iPhone (1G, 3G and 3GS) mobile phones for charging, connecting to a PC via USB or Firewire, to a stereo via line-out, to a serial device (controlled via the Apple Accessory Protocol).

This connector also exists in most Apple iPod MP3 players (iPod 3G, 4G, 5G Video, 5.5G Video, Nano (1G, 2G, 3G, 4G), Mini, Classic, Touch, Touch 2G)

Pin Signal Description
1 GND Ground (-), internally connected with Pin 2 on iPhone motherboard
2 GND Audio & Video ground (-), internally connected with Pin 1 on iPod motherboard
3 Right Line Out - R (+) (Audio output, right channel) . See also Apple iPhone headset  connector pinout
4 Left Line Out - L(+) (Audio output, left channel)
5 Right In Line In - R (+)
6 Left In Line In - L (+)
8
 
 
9
 
 
10
 
 
11 GND If connected to GND the iPhone sends audio signals through pin 3-4, otherwise it uses onboard speaker.
12 Tx iPhone sending line, Serial TxD
13 Rx

iPhone receiving line, Serial RxD

14 RSVD Reserved
15 GND Ground (-), internally connected with pin 16 on iPhone motherboard
16 GND USB GND (-), internally connected with pin 15 on iPhone motherboard
17 RSVD Reserved
18 3.3V 3.3V Power (+) ?
19,20 +12V Firewire Power 12 VDC (+)
21 Accessory Indicator/Serial enable

Different resistances indicate accessory type:
  1kOhm - docking station, beeps when connected
   68kOhm - makes iPhone 3g send audio through line-out without any messages
500kOhm - related to serial communication / used to enable serial communications Used in Dension Ice Link Plus car interface
  1MOhm - Belkin auto adaptor, iPod shuts down automatically when power disconnected Connecting pin 21 to ground with a 1MOhm resistor does stop the ipod when power (i.e. Firewire-12V) is cut. Looks to be that when this pin is grounded it closes a switch so that on loss of power the Ipod shuts off. Dock has the same Resistor.

22 TPA (-) FireWire Data TPA (-)
23 5 VDC (+) USB Power 5 VDC (+)
24 TPA (+) FireWire Data TPA (+)
25 Data (-) USB Data (-)
26 TPB (-) FireWire Data TPB (-)
27 Data (+)

USB Data (+)
Pins 25 and 27 may be used in different manner.

To charge an iPhone 3G / iPod Touch 2nd gen or Ipod Classic (6th Gen), usb data- (25) should be at 2.8v, usb data+(27) should be at 2.0v. This can be done with a few simple resistors: 33k to +5v (23) and 22k to gnd(16) to obtain 2v and 33k to +5v and 47k to gnd to obtain 2.8v. This is a notification to the iphone that it is connected to the external charger and may drain amps from the usb.

It's also possible to charge the iPod's or iPhone's battery to make use the of internal +3.3v output (18) terminal to connect the USB Data + (27) thru a 47k ohms resistor and the USB Data- (25) thru a 47k resistor to the USB Power source +5v (23).  This way the USB function is still useable for normal operations and makes it easier the fit in a plug. The resistors are not to critical 2x 150k's still work.

28 TPB (+) FireWire Data TPB (+)
29,30 GND FireWire Ground (-)








Back side of dock connector;
 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30
 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29

Pins 1,2 connected on motherboard.
Pins 15,16 connected on motherboard.
Pins 19,20 connected on motherboard.
Pins 29,30 connected on motherboard.

If you disassemble the original Apple iPhone dock connector cable and look at the connector itself, on the back side, where it is soldered, you can see the number 1 and 30 (e.g. pin 1 and 30). In this description NUMBERING is INVERSED: pin 1 is pin 30 and pin 29 is pin 2, so, don't look at numbers on connector.

This device may be connected to the firewire computer port by straight cable (TPB+/-, TPA +/- should be twisted pairs in cable). It seems there are no file transfer allowed, but it can charge via this interface.

 

На распиновку Разъем кабеля Apple iPhone (1G, 3G, 3GS, 4, 4S) есть 15 отзыв(а): 15 положительных и 0 отрицательных.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings