Pinouts >  Распиновки разъемов игровых приставок  >  Sony pinouts
9 pin Sony Playstation proprietary connector layout
Разъем 9 pin Sony Playstation proprietary
Dual force 2 Controller by Mad Catz
Pin Pin
Name
Description
1 DATA Brown wire = Pin 1 on control board
2 CMD Orange wire = Pin 2 on control board
3 9VDC White wire = Pin 4 on control board
4 GND Purple + Black wire: Purple = Pin 8 on control board. Black = pin 3 on control board
5 VCC Red Wire = pin 5 on control board
6 ATT Yellow wire = pin 6 on control board
7 CLK Blue wire = pin 7 on control board
8 N/C Not connected (not used in PSX or PS2 controls and often not present in plug). Used for Light Gun games.
9 ACK Green Wire = pin 9 on control board

This applies to the Mad Catz. Dual force 2, programmable controller for PSX, PSONE, and PS2. The control board pins are numbered, but if unable to see due to the resin, pin one has a square PCB pad. If looking at the control from underside, with the lower casing removed, the pins can be counted sequentially from left to right. There should be 9 in total. PLEASE NOTE: both purple and black wires are connected to the same pin (pin 4) If the black wire is not connected, the vibrate function will operate continuously.

 

Hi , the scheme it's very useful and mainly correct , but i switched the position of purple wire with grey\white wire , and the joypad worked !

На распиновку Playstation Dual Force 2 controller есть 6 отзыв(а): 5 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: www.dranoweb.com
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings