Pinouts >  Кабели для локальных сетей  >  Cisco pinouts
8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male

Rollover Cable:

You can identify a roll-over cable by comparing the two modular ends of the cable. Holding the cables side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug should be the same color as the wire connected to the pin on the outside of the right plug. If your cable was purchased from Cisco Systems, pin 1 will be white on one connector, and pin 8 will be white on the other.

Uses of Rollover Cable:

Rollover cables, like other cabling types, got their name from how they are wired. Rollover cables essentially have one end of the cable wired exactly opposite from the other. This essentially “rolls over” the wires- but why would we need to do such a thing? Rollover cables, also called Yost cables, usually connect a device to a router or switch’s console port. This allows a programmer to make a connection to the router or switch, and program it as needed.

PC to Console Port

Router AUX port to External Modem 

Router
Pin name
Router
Pin
Direction Workstation
Pin
Workstation
Pin name
White-Orange 1 8 Brown
Orange 2 7 White-Brown
White - Green 3 4 Blue
Green 6 5 White-Blue
White-Blue 5 6 Green
Blue 4 3 White-Green
White-Brown 7 2 Orange
Brown 8 1 White-Orange

 

Notice that each wire is simply “rolled over.” These types of cables are generally not used very much, so are usually colored differently from other types of cables. 

8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
На распиновку Cisco RJ45 RollOver cable есть 57 отзыв(а): 48 положительных и 2 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: , http://www.bohack.com/2009/11/cisco-console-cable-wiring/
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings