Pinouts >  UPS devices  >  APC pinouts
9 pin D-SUB female connector layout
9 pin D-SUB female connector
at the computer
APC Part# - 940-0023A

This cable can only be used on voltage-signalling UPSes, and apparently only provides the On Battery signal. As a consequence, this cable is pretty much useless, because all APC UPSes support more than just On Battery.

     
     Signal Computer                  UPS
            DB9F                     DB9M
      DCD    1   --------------------  2  On Battery
     
                   3.3K ohm
      TxD    3   --[####]-*
                          |
      DTR    4   ---------*
      GND    5   ---------------*----  4  Ground
                                |
                                *----  9  Common
not sure the following diagram is correct
9 pin D-SUB male connector layout
9 pin D-SUB male connector
at the UPS
Pinout status: +1 -0
According to 1 reports in our database (1 positive and 0 negative) the APC BackUPS dumb cable (on-battery only) pinout should be correct.

Is this pinout
NO DIY devices
Source(s) of this and additional information: www.apcupsd.com
Copyright © 2000-2025 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings