Pinouts >  UPS devices  >  APC pinouts
8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
APC AP9335T NetBotz Temperature Probe

The AP9335T is designed to connect to APC UPSes or NetBotz boxes to provide a temperature reading. I was hoping to see an IC inside the one I opened up, but its just a thermistor. It reads 9.8k Ohms at about room temperature, and resistance decreases as temperature increases. At body temperature it reads 6.9k. Pressed against an ice cube it reads 20k. Based on this, the thermistor seems to be a 2700k type.

1 Vcc Vcc for Type Sense
2   N/C
3 Type Sense Connected to Vcc via 0 to 0.4kOhm resistor
4   N/C
5   Shield N/C
6 White Thermistor
7 Black Thermistor
8   N/C

A 10K Thermistor may be used. Thermistor seems to be B0/50 K=3970 (may be 10k with B=3892K type)

There is also an AP9335TH.
It contains a temp-sensor and a humidity-sensor. Pin 1-3 should then have a 1k2 resistor. Position of the pins for humidity sensor is unknown.

8 pin RJ45 (8P8C) female connector layout
8 pin RJ45 (8P8C) female connector
According to 22 reports in our database (21 positive and 1 negative) the APC AP9335T NetBotz Temperature Probe pinout should be correct.

Is this pinout
APC AP9335T NetBotz Temperature Probe visual pinout:click to enlarge
Source(s) of this and additional information: ,
Copyright © 2000-2023 by team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings