Pinouts >  ИБП  >  APC pinouts
9 pin D-SUB male connector layout
Разъем 9 pin D-SUB male
may be used for building your own cable
Pin Signal Description
1 Shut Down (dumb mode) / RS-232 RX In (smart mode) Set high for 1-5 sec to activate shutdown.
2 Line Fail (dumb mode) / RS-232 TX Out (smart mode) On-battery power (normally low but goes high when the UPS switches to batteries)
3 Line Fail signal Mains down (normally low but goes high when line fail)
4,9 GND Ground, chassis
5 Low battery signal (normally low but goes high when low battery)
6 Line fail signal Inverse of pin 2 Line Fail signal
7 UPS Turn-on/off signal (on advanced UPSes only)
8 Unregulated +24 Vdc Out ??  
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Источник(и) этой и дополнительной информации: UPS FAQ in russian
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings