|
Cisco DB-60 to DB-60 specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| 2009-07-13 17:22:02 | rev. 1 | INCORRECT | Dear publishers, I don't know the exact way how to fix this problem. But recently I applied the documentation you provided online and couldn't connect my routers using that cable. I was also wondering what would be the case with the other cables that are not mentioned her. Please update me if you come up with a better solution. Thank you. | APPROVED |
| 2009-11-25 16:00:39 | rev. 1 | INCORRECT | This doesnt work. Thanks!!!! | APPROVED |
| 2009-12-10 12:26:40 | rev. 1 | CORRECT | No errors. This cable pinout is correct. I use it to connect cisco 1720 and 1750, both with WIC-1T. Hint: don't forget to enable clock on DCE side (use 'clock rate' command in appropriate serial interface config menu) | APPROVED |
| 2018-03-04 00:22:37 | rev. 2 | CORRECT | Works correctly, and can be manufactured from a pair of Cisco X.21 cables. You may have to modify the DB60 end of one of them if both are the same DxE type. The DCE end (MODE_DCE not grounded) needs to supply the clock, and shows in "show controllers" as "DCE V.11 (X.21), clock rate 2000000" or similar. The DTE end (MODE_DCE grounded) shows in "show controllers" as "DTE V.11 (X.21) TX and RX clocks detected" or similar. | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|
Pinouts.ru > Pinout of Cisco DB-60 to DB-60 and layout of 60 pin Cisco DB connector and 60 pin Cisco DB connector |
unknown |