Pinouts >  Audio / Video hardware connectors  >  Enttec pinouts
15 pin D-SUB female connector layout
15 pin D-SUB female connector
at the device
This is the pinout for the breakout port on the Enttec DMX PRO MK2 device.

Note that all grounds are NOT connected, i.e. isolated from eachother.

MIDI is basic note out/in, no standard midi interface at time of writing (3-jun-2013)

Pin
Number		 Pin
Name		 Description
1 DMX2_B(-) DMX2 - (pin 2)
2 NC Not connected
3 Vcc(5V) Max 250mA
4 Midi_out_GND Pin 2 on DIN5
5 Midi_out_Vcc Pin 4 on DIN5
6 Midi_out Pin 5 on DIN5
7 Midi_IN+ Pin 4 on DIN5
8 Midi_IN- Pin 5 on DIN5
9 DMX2_GND DMX2 Ground*
10 DMX2_A(+) DMX2 + (pin 3)
11 DMX1_A(+) DMX1 + (pin 3)
12 DMX1_B(-) DMX1 - (pin 2)
13 DMX1_GND DMX1 Ground*
14 NC Not connected
15 NC Not connected

Both silkscreen and breakout cable match

Comments:

DMX1 IN and DMX1 OUT are most probably wired in parallel to the same pins 11/12/13, since you can't use DMX1 IN and OUT simultaneously.

15 pin D-SUB male connector layout
15 pin D-SUB male connector
at the breakout cable
Pinout status: +5 -1
According to 7 reports in our database (5 positive and 1 negative) the Enttec DMX PRO MK2 pinout should be correct.

Is this pinout
NO DIY devices
1 Information source(s)
Enttec DMX PRO MK2 visual pinout:click to enlarge
Copyright © 2000-2025 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings