Pinouts >  Распиновки разъемов аудио/видео техники  >  Fujitsu pinouts
3 pin stereo plug connector layout
Разъем 3 pin stereo plug
fujitsu-lifebook 7020s s-video minijack to RCA compsite out

fujitsu lifebook7020s s-video minijack





1-Y>------------+
                +---> RCA Composite Signal
2-C>-----||-----+
3-GND---------------->RCA gnd

 

-||- is a  470pF Ceramic capacitor

i read on this site about convert s-video to composite , I try this connection on my lifebook 7020s and work well, for my hp dv6575 i use  adaptor from my old nvidia fx... video card to conect on tv .

 

 

Comment:

On my FS Lifebook S7110 this schema did not work for me first, but then I figured out that the Y and C signals in the S7110 notebook are actually swapped! Y signal is on pin 2 (R of the stereo jack) and C signal on pin 1. So I swapped the lines in the connector and it started working!
Note: I was actually making a jack -> S-video cable (I did not join signals into composite using the capacitor), so I have a working confirmed S-Video output. I am going to make also the composite cable, as on the scheme above, so I will confirm composite output later, but this should work since I have S-Video out working (and conversion to composite it standard like here: http://pinouts.ru/VideoCables/svideo2RCA_pinout.shtml .

Additional comment:

Some TVs have a high impedance input for that would define the device is connected to video input or not, and so the video chipset in the laptop can not enable video output. In order to be all earned enough in the channel Y to solder a resistor of 75 ohms between the signal and earth.
 

2 pin RCA plug connector layout
Разъем 2 pin RCA plug
На распиновку Fujitsu lifebook s-video minijack to RCA composite out есть 2 отзыв(а): 2 положительных и 0 отрицательных.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings