Pinouts >  Digital cameras and camcorders interfaces  >  Canon pinouts
3 pin N3 Canon plug connector layout
3 pin N3 Canon plug connector
at the Canon cable
with N3 connector. The connector may be obtained from wired remote control
The pinout should fit 11 devices/models. Click to list>


 

Pin
Number		 Pin
Name		 Description
3 GND Ground
2 FOCUS short to pin 3 to focus Canon camera
1 SHUTTER short to pin 3 to trigger shutter

If the camera is in stand-by mode, there is a 3.3V voltage present at the focus wire. The camera can be waken up from stand-by by connecting the focus wire to ground. The trigger inputs can serve as power supply for circuits with a supply current of less than 30µA.

Pinout status: +1 -0
According to 1 reports in our database (1 positive and 0 negative) the Canon N3 manual shooter / focus for EOS 10D, 20D, 30D, 40D, 50D, 5D, 5Dmk2, 7D connector pinout should be correct.

Is this pinout
1 DIY device(s)
Canon N3 manual shooter / focus for EOS 10D, 20D, 30D, 40D, 50D, 5D, 5Dmk2, 7D connector visual pinout:click to enlarge
Source(s) of this and additional information: http://www.doc-diy.net/photo/eos_wired_remote/
Copyright © 2000-2025 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings