Pinouts >  Digital cameras and camcorders interfaces  >  Dakota pinouts
10 pin PALM proprietary connector layout
10 pin PALM proprietary connector
at the camera
May be used to build your own USB cable and connect this camera to the comuter.

Pin 1 is closest to the shutter release button, and pin 10 is closest to the battery door at the bottom. The connector is the same type used on the older Palm Pilots e.g. Palm III, VIII Hotsync Cable (with some peeling).

Pin Signal Name Description
1
 
 		 goes to R57 (unpopulated), to U2.79. Use unknown.
 
2
 		 Ground
 
3
 
 		 R18 (4.7K) - U2.30 (P31) & delete button. Also through R68 (unpopulated) to JP1.2
4
 
 		 R2 (unpopulated) - pin 6 of SST program memory FLASH. This is address bit 17, which isnt used by the size FLASH memory installed.
 
5
 
 		 R5 (1K) - U2.33 (P13). Use unknown.
 
6
 		 USB +5V power
 		 Connects to red wire.
 
7
 		 USB Ground
 		 Connects to black wire (you can also use pin 2 or 10).
 
8
 		 USB Data +
 		 Connects to green wire.
 
9
 		 USB Data -
 		 Connects to white wire.
 
10
 		 Ground
 
 
 
Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
Dakota digital camera USB visual pinout:click to enlarge
Source(s) of this and additional information: Disposable Digital Camera Interfacing, < a href="http://cexx.org/dakota/">cexx.org/dakota
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings