Pinouts >  Digital cameras and camcorders interfaces  >  Sony pinouts
3 pin stereo plug connector layout
3 pin stereo plug connector
at the camera (2.5 mm jack used)
this cable may be used for dump/restore camcorder's firmware, unlock DV-in, change internal registers in Sony camcorders

The plug on the left is the 2.5-mm stereo jack that is used for the LanC connection (LANC signal marked by L) on the camcorder, whereas the DB25M connector on the right is a male LPT 25-pin connector and connects to your PC. The cable in between is approx. 3-feet in length and is shielded, whereas the transistor, or rather mosfet, is a common N-channel mosfet rated at 60-volts, the BS-170.

This cable is designed to work with EPP or ECP printer ports only and will not work with SPP or Normal settings. Some notebooks might not be able to supply enough power to their printer port to use the interface cable successfully.

Programs designed to work with this cable are: RM95 (makes the firmware dump), DVin Lite (modify the camcorder´s registers), LANCTERM . Refer to source link for explanations.
25 pin D-SUB male connector layout
25 pin D-SUB male connector
at the computer
Pinout status: +1 -0
According to 1 reports in our database (1 positive and 0 negative) the Sony LANC cable pinout should be correct.

Is this pinout
1 Related pinout(s)
NO DIY devices
Source(s) of this and additional information: hardwareanalysis.com
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings