Pinouts >  Various Electronic Devices  >  Dell pinouts

10 pins connector
RD530 Bluetooth Card used in many Dell laptops. Not sure if the connector is a JST 1 mm compatible.
	| | | | | | | | | |
       10 9 8 7 6 5 4 3 2 1
         |---------------|
         |               |
         |               |
         |---------------|

	O

 

Pin
Number		 Pin
Name		 Description
1 GND Ground
2 USB_D+ USB Data +. Must be routed with USB_D- as a 90 Ohm differential pair.
3 USB_D- USB Data-. Must be routed with USB_D+ as a 90 Ohm differential pair.
4 USB_PWR This is a 5V rail that is used by bus-powered USB devices. The module does not actually draw power from this pin, uses this pin to detect whether the USB host port is powered so as to avoid latch-up conditions.
5 RSVD Reserved. This pin may be used for resolving coexistence with the 802.11 radio(s) on the MPCI card in the platform.
6 HW_RADIO_DIS# Active low input from the platform to the card to disable all the radios onn the module from transmitting.
7 RSVD Reserved. This pin may be used for resolving coexistence with the 802.11 radio(s) on the MPCI card in the platform.
8 +3.3V This is the rail from which the module powers itself (as a self-powered USB device
9 LED_BT_RadioState Active-high LED drive signal for indicating the state of the Bluetooth Radio. This LED should not have a flashing feature
10 GND NC

 

Pinout status: +1 -0
According to 1 reports in our database (1 positive and 0 negative) the Dell RD530 Bluetooth card pinout should be correct.

Is this pinout
NO DIY devices
Dell RD530 Bluetooth card visual pinout:click to enlarge
Source(s) of this and additional information: http://www.zaebiz.net/GX740/Dell-RD530-Bluetooth-Card-Pin-Out.htm http://www.notebookforums.com/t/218198/dell-truemobile-bluetooth-connector-pinout#post_3019225
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings