Pinouts >  Распиновки модулей и карт памяти
9 pin SD-card proprietary connector layout
Разъем 9 pin SD-card proprietary
Secure Digital (SD) is a flash memory memory card format used in portable devices, including digital cameras and handheld computers.

SD cards are based on the older Multi Media Card (MMC) format, but most are physically slightly thicker than MMC cards. They also boast higher data transfer rates. DRM features are available but are little-used. SD cards generally measure 32 mm × 24 mm × 2.1 mm, but can be as thin as 1.4 mm, just like MMC cards.

There are different speed grades available. They are referred to with the same nx notation as CD-ROMs; a multiple of 150 kB/s. Devices with SD slots can use the thinner MMC cards, but the standard SD cards will not fit into the thinner MMC slots. MiniSD and MicroSD cards can be used directly in SD slots with an adapter. There are readers which allow SD cards to be accessed via many connectivity ports such as USB, FireWire.

Pin SD Mode SPI Mode
Name Type Description Name Type Description
1 CD/DAT3 I/O/PP Card detection / Connector data line 3 CS I Chip selection in low status
2 CMD PP Command/Response line DI I Data input
3 Vss1 S GND VSS S GND
4 Vdd S Power supply VDD S Power supply
5 CLK I Clock SCLK I Clock
6 Vss2 S GND VSS2 S GND
7 DAT0 I/O/PP Connector data line 0 DO O/PP Data output
8 DAT1 I/O/PP Connector data line 1 RSV    
9 DAT2 I/O/PP Connector data line 2 RSV    

SD cards interface is compatible with standard MMC card operations. All SD memory and SDIO cards are required to support the older SPI/MMC mode which supports the slightly slower four-wire serial interface (clock, serial in, serial out, chip select) that is compatible with SPI ports on many microcontrollers. Many digital cameras, digital audio players, and other portable devices probably use MMC mode exclusively. MMC mode does not provide access to the proprietary encryption features of SD cards, and the free SD documentation does not describe these features. As the SD encryption exists primarily for media producers, it is not of much use to consumers who typically use SD cards to hold unprotected data.

There are three transfer modes supported by SD: SPI mode (separate serial in and serial out), one-bit SD mode (separate command and data channels and a proprietary transfer format), and four-bit SD mode (uses extra pins plus some reassigned pins) to support four bit wide parallel transfers. Low speed cards support 0 to 400 kbit/s data rate and SPI and one-bit SD transfer modes. High speed cards support 0 to 100 Mbit/s data rate in four-bit mode and 0?25 Mbit/s in SPI and one-bit SD modes.

SD cards security features includes:

  • Copyright protection mechanism with the SDMI standard (Secure Digital Music Initiative)
  • Integrated CPRM file protection and encryption system (CPRM is a Content Protection for Recordable Media)
На распиновку Secure Digital (SD) card есть 29 отзыв(а): 27 положительных и 2 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: wikipedia.org
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings