Pinouts >  Распиновки разных разъемов на материнской плате
10 pin IDC male connector layout
Разъем 10 pin IDC male
Used for card-edge bracket additinal USB ports and internal cardreaders. This is very old and does not match most modern mother board usb headers.

On the old mainboards (Pentium III) 8-pin IDC male connector is used with pins for 2-nd USB port in reversed order. Sometimes more exotical layouts were used. 

Pin Signal Description
1 Vcc +5V for USB port 1
3 Data0- for USB port 1
5 Data0+ for USB port 1
7 GND for USB port 1
9 keyed  
2 Vcc +5V for USB port 2
4 Data1- for USB port 2
6 Data1+ for USB port 2
8 GND for USB port 2
10 N/C  

This is a sample pinout from Epox motherboard manual. It may be DIFFERENT for other motherboards.

 

In various MB USB pin for 2nd port is reversed. V+ swap with GND and D- with D+ ! Detect direction by power pins before connect.

Before connecting any external bracket you should check them and replug wires according to your motherboard manual USB pinout (if needed).
If you have no access to the motheboard manual, you can try determine pinout manually by finding GND and +5V manually with multimeter.
USE AT YOU OWN RISK! May be dangerous for your equipment!
 

 

WARNING! !!!
Old motherboard one series in the connector can be deployed in the opposite direction!!!

На распиновку USB header internal connector есть 15 отзыв(а): 15 положительных и 0 отрицательных.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings