Pinouts >  Point Of Sale Devices: scanners, printers, cash registers cables and connectors  >  Uniden pinouts
4 pin uniden connector layout
4 pin uniden connector
also for BC246T/BR330T/BCD396T/ BC346XT/BCD396XT/BCT15/BCD996T

The connector that plugs into these scanners is the same as that used by devices from Casio, Fuji, Konica Minolta and Toshiba. A list of devices that use this connector can be found below. Cables for these devices can be found very inexpensively and can then be modified for use with Uniden scanners.

The cable for those devices have a USB connector at the other end that you will have to remove and replace with a 9-pin D-Sub female. DO NOT use the cable to connect your scanner to the USB port of your PC. You will damage your scanner and possibly your PC. You MUST replace the USB connector on the cable with a serial connector. Once you replace the USB connector with a serial connector, DO NOT use the cable to connect devices other than your Uniden scanner.

The 4-pin connector is mounted vertically on the scanner and the pins are numbered from the top of the scanner (where the antenna is) down to the bottom.


 

Uniden D-Sub Description
Pin Assignment Pin Assignment
1 TXD 2 RXD Data transfer from scanner to PC
2 CTS 8 CTS Clear to send
3 RXD 3 TXD Data transfer from PC to scanner
4 GND 5 GND Ground

 

 

9 pin D-SUB female connector layout
9 pin D-SUB female connector
According to 3 reports in our database (3 positive and 0 negative) the Uniden Bearcat BC250D, BC296D, UBC-3300XLT Scanner PC Programming Cable pinout should be correct.

Is this pinout
Uniden Bearcat BC250D, BC296D, UBC-3300XLT Scanner PC Programming Cable visual pinout:click to enlarge
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings